Niles Audio ZR-6 manual Erasing A Single Learned Button, Restoring All Button Functions, Tech Tip

PROGRAMMING THE REMOTE

PROGRAMMING THE R-8L HAND-HELD LEARNING REMOTE CONTROL

ERASING A SINGLE LEARNED BUTTON

A button can return to its original programming for a selected device. A button can also be taught a new function using the “Programming A Learned Key” procedure in the prior section.

Please note that if more than ten seconds pass between button presses, the remote exits the programming mode.

To Erase a Single Learned Button:

1.Press the Source button for the device whose code is to be erased.

2.Press-and-hold the Setup button until the selected Source button’s LED blinks twice, then release.

3.Enter 9 7 6. The Source button LED blinks twice.

4.Press the button twice that contains the learned function

to be erased. The Source button LED blinks twice and the R-8L remote exits the programming mode.

ERASING ALL LEARNED BUTTONS FOR A SPECIFIC DEVICE

Please note that if more than ten seconds passes between button presses, the remote exits the programming mode.

To Erase All Learned Buttons For A Specifi c Device:

1.Press-and-hold the Setup button until the selected Source button’s LED blinks twice, then release.

2.Press 9 7 6. The Source button LED blinks twice.

3.Press a Source button twice to clear all the learned buttons for that device. The Source button LED blinks twice and the R-8L exits from the programming mode.

RESTORING ALL BUTTON FUNCTIONS

TO FACTORY SETTINGS

Please note that if more than ten seconds passes between button presses, the remote exits the programming mode.

To Restore All Button Functions To Factory Settings:

1.Press-and-hold the Setup button until the selected Source button’s LED blinks twice, then release.

2.Press 9 8 0. The Source button LED blinks four times.

3.Press-and-hold the Setup button until the red LED blinks twice, then release.

PROGRAMMING A SEQUENCE

TECH TIP

Any button on the Niles R-8L Hand-Held Learning Remote Control (except the Setup button) can be

programmed with a sequence. A sequence is a set of sequential commands initiated by one press of a

button. A typical home theater sequence might turn the TV on, turn the home theater receiver on, select the proper input on the receiver, select the proper input on the TV, turn the DVD player on, and put the DVD player in to the play mode.

Please note that programming a new sequence over an existing one erases the original sequence.

To Program a Sequence:

1.Press a Source button.

2.Press-and-hold the Setup button until the selected Source button’s LED blinks twice, then release

3.Press 9 7 8. The Source button LED blinks four twice.

4.Press the button that the sequence is to be assigned to

5.Enter the series of commands, in the desired order, that the sequence is to execute (up to 15 commands).

6.Press-and-hold the Setup button until the red LED blinks twice, then release.

TECH TIP

When the button that has been programmed with the sequence is pressed, the remote sends the

series of commands, but only if the source device selected in Step 1 is selected. For example, A

sequence key can be programmed to turn on both the TV and the cable box, but only if TV is selected as the source. If DVD is selected, the button does not execute the sequence for the TV.

7.To clear the sequence, repeat steps 1-6 above, but do not enter a series of commands at step 5.

62 NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373