9.Allow detergent to "soak in" for 3-5 minutes before washing and rinsing. Reapply as needed to prevent surface from drying. DO NOT allow detergent to dry on (prevents streaking).

IMPORTANT: You must flush the detergent siphoning system after each use by placing the filter into a bucket of clean water, then run the pressure washer with black detergent nozzle for 1-2 minutes.

Pressure Washer Rinsing

1.Engage the trigger lock.

2.Remove black detergent nozzle from nozzle extension.

3.Select and install desired high pressure spray tip following instructions How to Use Spray Tips.

4.Keep spray gun a safe distance from area you plan to spray.

WARNING

Kickback from spray gun can cause you to fall.

•Operate pressure washer from a stable surface.

•Be extremely careful if you must use the pressure washer from a ladder, scaffolding, or any other similar location.

•Firmly grasp spray gun with both hands when using high pressure spray to avoid injury when spray gun kicks back.

5.Increase (decrease) spray pressure by turning pressure control knob (A) clockwise (counterclockwise). Use lower pressure to wash items such as a car or boat. Use higher pressure to strip paint and degrease driveways.

A

6.Apply a high pressure spray to a small area and then check surface for damage. If no damage is found, you can assume it is okay to continue rinsing.

7.Start at top of area to be rinsed, working down with same overlapping strokes as you used for cleaning.

Cleaning Detergent Siphoning Tube

If you used the detergent siphoning tube, you must flush it with clean water before stopping the engine.

1.Engage trigger lock on spray gun.

2.Remove high pressure spray tip from nozzle extension.

3.Select and install black detergent nozzle.

4.Place detergent siphoning tube/filter in a bucket full of clean water.

5.Flush for 1-2 minutes.

6.Shut off engine following instructions How to Stop Pressure Washer and turn off water supply.

7.ALWAYS point spray gun in a safe direction, squeeze spray gun trigger to release retained high water pressure.

IMPORTANT: Spray gun traps high water pressure, even when engine is stopped and water is disconnected.

WARNING

The high pressure stream of water that this equipment produces can cut through skin and its underlying tissues, leading to serious injury and possible amputation.

Spray gun traps high water pressure, even when engine is stopped and water is disconnected, which can cause injury.

•Keep high pressure hose connected to pump and spray gun while system is pressurized.

•ALWAYS point spray gun in safe direction and squeeze spray gun trigger, to release high pressure, every time you stop engine. Engage trigger lock when not in use.

Automatic Cool Down System (Thermal Relief)

If you run the engine on your pressure washer for

3-5 minutes without pressing the trigger on the spray gun, circulating water in the pump can reach temperatures above 125°F. The system engages to cool the pump by discharging the warm water onto the ground.

16

BRIGGSandSTRATTON.COM