Assembly

Read entire operator’s manual before you attempt to assemble or operate your new pressure washer.

Your pressure washer requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your pressure washer, please call the pressure washer helpline at

(800)743-4115. If calling for assistance, please have model, revision, and serial number from data tag available.

Unpack Pressure Washer

1.Remove the parts bag, accessories, and inserts included with pressure washer.

2.Open carton completely by cutting each corner from top to bottom.

3.Ensure you have all included items prior to assembly.

Items in the carton include:

• Main Unit

• Handle

• Quick Connect Spray Gun

• Nozzle Extension

•Detergent Nozzle with Detergent Siphoning Tube/Filter

•Turbo Nozzle

•High Pressure Hose

•Oil Bottle(s)

•Safety Goggles

•Operator’s Manual

•Owner’s Registration Card

•4 Multi–Colored Spray Tips

To prepare your pressure washer for operation, you will need to perform these tasks:

1.Fill out and send in registration card.

2.Attach handle to base.

3.Add oil to engine crankcase.

4.Add fuel to fuel tank.

5.Connect high pressure hose to spray gun and pump.

6.Attach spray gun and nozzle extension.

7.Connect water supply to pump.

8.Select/attach quick connect spray tip to nozzle extension.

Attach Handle

1.Place handle (A) onto handle supports (B) connected to main unit. Make sure holes (C) in handle align with holes on handle supports.

A

C

B

NOTE: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the handle supports.

2.Insert carriage bolts through holes from outside of unit and attach a plastic knob from inside of unit. Tighten by hand.

3.Insert multi-colored quick connect spray tips and other supplied accessories in spaces provided on handle.

Add Engine Oil

1.Place pressure washer on a flat, level surface.

2.Clean area around oil fill and remove yellow oil fill cap/dipstick.

NOTE: See Oil Recommendations in Maintenance section. Verify provided oil bottle is the correct viscosity for current ambient temperature.

3.Using oil funnel (optional), slowly pour contents of provided oil bottle into oil fill opening to the “Full” mark on dipstick. DO NOT overfill. DO NOT add engine oil to pump crankcase.

NOTICE

Improper treatment of pressure washer can damage it and shorten its life.

•DO NOT attempt to crank or start the engine before it has been properly serviced with the recommended oil. This may result in an engine failure.

4.Replace oil fill cap and fully tighten.

8

BRIGGSandSTRATTON.COM