Briggs & Stratton 074000 Compressor is not, Supplying enough air to Operate accessories

TROUBLESHOOTING

PROBLEM	CAUSE		CORRECTION
	1.	Prolonged excessive use of air.	1.	Decrease amount of air used.
	2.	Compressor is not large enough for air	2.	Check the accessory requirement. If it is
		requirement.		higher than the CFM or pressure supplied by
Compressor is not				your air compressor, you need a larger
				capacity air compressor.
supplying enough air to
operate accessories.	3.	Hole in hose.	3.	Inspect and replace if required.
	4.	Check Valve restricted or leaks air.	4.	Contact trained service technician.
	5.	Restricted air intake filter.	5.	Clean or replace air intake filter
				(see page 13).
	1.	Motor Overload Protector switch has	1.	Let motor cool for 15 minutes. Press RESET
		tripped.
				to reset Overload Protector switch.
	2.	Tank pressure exceeds Pressure Switch
			2.	Motor will start automatically when tank
		“cut-in” pressure.
				pressure drops below “cut-in” pressure
	3.	Loose electrical connections.		setting.
			3.	Contact trained service technician.
	4.	Possible defective motor or starting	4.	Contact trained service technician.
		capacitor.
	5.	Pressure Release Valve on Pressure	5.	Drain pressure by setting ON - OFF Switch
		Switch has not unloaded head pressure.
				to OFF. If the Pressure Release Valve does
Motor will not run.				not open, contact trained service technician.
	6.	Fuse blown, circuit breaker tripped.	6A.	Check fuse box for blown fuse and replace as
				necessary. Reset circuit breaker. DO NOT use
				a fuse or circuit breaker with higher rating
				than that specified for that branch circuit.
			B.	Check for proper fuse. Use a time delay fuse.
			C. Check for low voltage conditions and/or
				proper extension cord.
			D. Disconnect all other electrical loads from
				circuit used by air compressor OR operate
				air compressor on dedicated branch circuit.
				Contact trained service technician.

17