Briggs & Stratton PRO8000 manual Assembly, Install Wheel Kit, Unpack Generator, Shipment Contents

Assembly

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at (800) 743-4115. If calling for assistance, please have the model, revision, and serial number from the identification label available. See Controls and Features for identification label location.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.

You will need the following tools to install these components:

•13 mm and 3/8” wrench

•Socket wrench with a 13 mm and a 3/8” socket

•Pliers

•Safety glasses

Install the wheel kit as follows:

Unpack Generator

1.Set the carton on a rigid, flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Shipment Contents

The generator is supplied with:

•Engine oil

•Operator’s manual

•Battery charge cables

•Battery float charger

•Wheel kit

•120/240 Volt, 30 Amp locking plug

•120 Volt, 30 Amp locking plug

1.Tip generator so that engine side is down.

2.Slide axle (A) through both mounting brackets.

3.Slide a wheel (B) over axle.

NOTE: Be sure to install wheel with raised hub inboard.

4.Place a washer (C) on axle and then place an e-ring (D) in axle groove.

CAUTION E-rings can cause eye injury.

E-rings can spring back and become airborne when installing or removing.

•Always wear eye protection when installing/removing e-rings.

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

6.Repeat steps 3 through 5 to secure second wheel.

N	K
	M
	J
	L
	H
	F
	E
	G
	A
	B
	C
	D
	7