7.Tip generator so that engine end is up.

8.Attach clamps (E) to brackets (F) on both sides of generator with 1/4 - 20 hex screws (G).

9.Repeat steps 2 through 5 to secure the third and fourth wheels.

10.Attach handles (H) to brackets on generator frame as shown, with 45 mm capscrews (J), flat washers (K), nylon washers (L), and M8 lock nuts (M).

NOTE: DO NOT overtighten. Handles must be able to move up and down freely.

11.Return generator to normal operating position (resting on wheels).

12.To apply brakes, push down firmly on handle of both clamps until it locks in the down position and engages the wheels.

IMPORTANT: The generator is designed to be used on level surfaces.

13.Loop handle pins (N) on generator frame just above handle brackets.

14.Raise handles and insert handle pins to move generator.

15.To release brakes, pull up on handle of both clamps until it locks in the up position.

Attach Negative Battery Cable

Your unit is equipped with electric start capability but can be started manually. If you choose not to use the electric start feature, you do not need to connect the negative battery cable.

The sealed battery on the generator pre–installed except for the negative (black) battery cable.

WARNING Battery posts, terminals and related accessories contain lead and lead compounds - chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling.

To install:

1.Cut off tie wrap securing loose end of negative (black) cable.

2.Using an 8 mm or 5/16” socket wrench, remove screw (A), lock washer (B) and flat washer (C) on negative battery terminal.

C

B

D A

3.Slide lock washer, flat washer and negative battery cable (D) over screw as shown.

4.Reattach screw to negative battery terminal and tighten.

5.Verify that connections to battery and generator are tight and secure.

NOTE: If your battery is discharged, charge prior to use following the instructions in the section Battery Charger.

8

BRIGGSandSTRATTON.COM

Page 8
Image 8
Briggs & Stratton PRO8000 manual Attach Negative Battery Cable, Tip generator so that engine end is up, To install