Troubleshooting, Adjustments, & Service
Seat Adjustment
The seat and ground speed control levers should be adjusted so that operator’s elbows are supported by the arm rests when his/her hands are on the controls, and the ground speed control levers can be moved through their full range of motion without contacting the operator’s legs.
Seat Position Adjustment
The seat can be adjusted forward and back. Move the adjustment lever (A, Figure 30) towards the left hand side of the machine, slide the seat to the desired position, and release the lever.
A
Figure 30. Seat AdjustmentA. Adjustment Lever
| Reproduction |
|
| ||
Ground Speed Control Lever | for |
|
| ||
Adjustment |
|
|
| ||
The control levers can be adjusted in three ways. The |
|
| A | ||
alignment of the control levers, the placement of the |
|
|
|
| |
levers (how close the ends are to one another) and |
|
|
|
| |
the height of the levers can be adjusted. |
|
|
|
| |
| To Adjust the Handle Alignment: LoosenNotthe m unt |
|
|
| ||
bolts (A, Figure 31) and pivot the lever(s) (C) to align |
|
|
|
| |
with each other. |
|
| B |
|
|
| To Adjust the Handle Placement: Loos n the jam |
|
|
|
| |
nuts and adjust the placement bolt (B, Figure 31) in or |
| C |
| ||
out to properly adjust the lever end spacing. |
|
|
| ||
|
|
|
| ||
| To Adjust the Handle Height: emove the mounting | Figure 31. Control Lever Adjustment |
| |||
hardware and reposition the handle either up or down |
| ||||
| A. Alignment Hardware |
|
| |||
from its original position. You will need to readjust the |
|
| |||
handle alignment as described above. |
| B. Placement Hardware |
|
| |
|
|
|
| ||
34 | www.simplicitymfg.com www.snapper.com |