FaultPossible CauseRemedy
GB | Abnormal noises, | Bolts at motor, its fixings or | Tighten bolts. |
| |||
| lawnmower rattles. | mower housing are loose. |
|
Lawnmower does not run smoothly or vibrates vigorously.
Blade damaged (out of balance), cutter bar fixings at motor shaft loose.
Tighten bolts for blade. Damaged parts must be replaced at an authorised service centre.
Lawn turning yellow, | Blade is too blunt, | Change blade and / or use |
cut not clean. | cutting height too low. | a slightly higher cutting height. |
|
|
|
Mower leaves deep tracks. | Ground softened by water, | Allow lawn to dry, |
| lawn too wet. | do not mow if grass is wet. |
|
|
|
Motor not running. | No power supply. | Check power is available. |
| Extension cord defective. | Unplug the plug from the mains |
|
| power! Check the extension cord. |
Motor cuts out. | Blockage due to foreign object |
| or unit jammed. |
Switch off the motor.
Unplug the plug from the mains power! Remove foreign object or reason for blockage.
11. Instructions for correct use, safety instructions
Check each time you use Athe equipment
Inspect the equipment each time before you use it. Do not use the equipment if safety devices (switch handle, safety covers) and / or if the cutting device is damaged or worn. Never disable safety devices.
Check the work area before starting work. Remove any foreign bodies present (e. g. stones, branches or bones). Check for foreign bodies whilst working.
Always wear strong shoes and long trousers whilst working. Do not work barefoot or in light- weight sandals.
Check the cutting tools regularly for damage and have them repaired correctly if necessary.
Only have cutting tools replaced by Brill Service or your authorised specialist dealer.
Use /
AResponsibility
Make sure that there are no other people (especially children) or animals within or near the working area.
Powered equipment can cause serious injuries! You are responsible for safety in the area where you are working. Never start the equip- ment whilst tilted – risk of injury!
Always use the equipment solely for the purpose described in the operating instructions.
Only work in daylight or with adequate artificial lighting.
Ensure that you are standing safely and on firm ground, even on a slope.
Work across the slope, never up and down.
Do not work on excessively steep slopes.
Be careful if you change direc- tion on a slope, turn the
machine round or draw it towards you.
Be careful if you are going back- wards, risk of stumbling!
Only push the equipment at walking pace.
Turn the motor off if the equip- ment has to be tilted when trans- porting it over surfaces other than grass and if you are transporting the equipment backwards and forwards to the work area.
Never use the machine with damaged protective devices or without protective devices.
When starting or operating the starter switch take care as stipulated by the manufacturer’s instructions. Ensure that your feet are far enough away from the cutting tool.
When starting or switching on the motor, the machine should not be tilted unless the machine has to be raised during the process. In this case only tilt it as far as absolutely necessary and only raise the side away from you.
20
