Lighting the Side Burner | Brinkmann 9620 specification

Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.

LIGHTING THE SIDE BURNER:

1.Open lid before lighting side burner.

2.Make sure control knob is in the "OFF" position.

3. Push and turn side burner control knob to the "HIGH" position.

4.Press the electronic igniter on the main control panel and hold for 3–5 seconds to light burner.

5.If ignition does NOT occur in 5 seconds, turn control knob to

"OFF", wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6. To turn off, turn the control knob clockwise until it locks in the "OFF" position.

MATCH LIGHTING THE SIDE BURNER:

1.Open the lid to the side burner before lighting.

2.Turn the burner control knob to "OFF".

3.Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.

4.Turn the side burner control knob to the "HIGH" position. The burner should light within 5 seconds.

5.If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure.

6.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.

Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.

LIGHTING THE ROTISSERIE BURNER:

1. Open grill hood before lighting rotisserie burner.

2. Make sure control knob is in the "OFF" position.

3.	Push and turn the control knob to the "HIGH"	Pilot
	position. Press the electronic igniter for 3–5 seconds	Pilot
	position. Press the electronic igniter for 3–5 seconds	Flame
	to light burner.	Flame
	to light burner.
4.	If ignition does NOT occur in 5 seconds, turn control
	knob to "OFF”, wait 5 minutes to allow gas to dissipate
	and repeat lighting procedure.
5.	To turn off, turn control knob clockwise until it locks in the
	"OFF" position.

11

Image 12

Brinkmann 9620 owner manual Match Lighting the Side Burner, Lighting the Rotisserie Burner

Contents

9620 Important Safety Table of Contents General Warnings Installation Information LP GAS Cylinder not Supplied with this Grill Cylinder Specifications Installing the LP GAS Cylinder Onto the Grill Regulator Resetting ProcedureFilling the LP GAS Cylinder Hose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder Connecting Hose and Regulator Leak Testing When to Perform a Leak TestChecking for Leaks PRE-START Check List Lighting Instructions Lighting the Main BurnersMatch Lighting the Main Burners Lighting the Side Burner Match Lighting the Side BurnerLighting the Rotisserie Burner Match Lighting the Rotisserie Burner Turning OFF the Grill Operating the Grill Breaking in Your GrillPreheating the Grill Controlling FLARE-UPS Rotisserie Cooking Side Burner Cleanliness Grilling to Proper TemperatureHelpful Hints Cleaning and Maintenance Burner ASSEMBLY/MAINTENANCE Proper Burner Operation Cooking GrillsHeat Distribution Plates Transporting and Storage Trouble Shooting Before Storing Your Grill Frequently Asked Questions Frequently Asked Questions Assembly Instructions Parts ListPage Parts BAG Contents Step Attach four casters to legs. Tighten with wrench Step Step Without leak testing all Step Hang grease cup from brackets ProSeries 9620 Assembled Importantes Advertencias DE Seguridad Peligro Índice Advertencias Generales Información DE Instalación Especificaciones DEL Cilindro Llenado DEL Cilindro DE GAS DE Propano Líquido Manguera Y ReguladorProcedimiento DE Reposición DEL Regulador Conexión DE Lamangueray Regulador Pruebas DE Detección DE Fugas Cuándo Realizar UNA Prueba DE Detección DE FugasVerificación DE Ausencia DE Fugas Lista DE Verificación Preliminar AL Encendido ¡PRECAUCIÓN Instrucciones DE Encendido Encendido DE LAS Hornillas PrincipalesEncendido DE LAS Hornillas Principales CON UN Cerillo Encendido DE LA Hornilla Lateral Encendido DE LA Hornilla Lateral CON UN CerilloEncendido DE LA Hornilla DEL Asador Estilo Rotisserie ¡CUIDADO Apagado DE LA Parrilla Operación DE LA Parrilla Preparación DE LA Parrilla Para Usarla POR Primera VEZPrecalentamiento DE LA Parrilla Control DE LAS Llamaradas Cocción Estilo Rotisserie LA Hornilla Lateral Limpieza Cocinar a LA Parrilla a LA Temperatura ApropiadaRecomendaciones Útiles Limpieza Y Mantenimiento INSTALACIÓN/MANTENIMIENTO DE LAS Hornillas Continuacion DE INSTALACIÓN/MANTENIMIENTO DE LAS Hornillas Operacion Apropiada DE HornillaRejillas Para Cocinar Placas DE Distribución DEL Calor Identificación Y Corrección DE Problemas Antes DE Guardar LA Parrilla Preguntas Frecuentes Preguntas Frecuentes Contenido DE LA Bolsa DE Partes Instrucciones DE Armado Lista DE PartesPage Paso Paso Paso Paso Inserte los dos tornillos que se asocian Paso Bandeja para ProSeries 9620 Armada Warranty