Step 13
Slide baskets into slots located on inside of doors.
Step 14
Attach right side panel between straight legs using four #8 X 3/8" sheet metal screws. Panel should be mounted with louvers toward bottom of panel. Then add four plastic inserts into holes on straight legs.
Step 15
Remove button cap and retaining nut from igniter. Feed threaded end of igniter through hole on the control panel from back side and secure with retaining nut.
Retaining nut
Insert this end |
|
into hole | Igniter |
Step 16
To install battery unscrew igniter button cap. Insert battery with positive end towards button. Replace igniter button cap.
Step 17
Attach control valve manifold to control panel using screws and split lock washers provided with manifold. One screw hole is offset for proper installation.
NOTE: Manifold will have offset holes and can only be installed by aligning holes in manifold with holes in
23control panel.
Sheet Metal Screws
screw from inside of Panel
Louvers
Four - Plastic inserts
Hose/Regulator
Control Valve Manifold
