Britax BB0-702-00 manual Seat cover dia 3b inset, Feed the seat belt through the belt, Dia 3c

3. Installing your child seat (rearward facing) in rear middle seat

3a	IMPORTANT - The child seat MUST only be used with a lap or a lap and
	diagonal seat belt (approved to UN/ECE regulation no. 16 or equivalent

standards).

With the footprop adjusted to the shortest length, place the child seat rearward facing on the car seat with the back of the child seat positioned centrally between the driver and passenger seat and with the swinging base resting against the back of the vehicle seat (dia 3a).

3b

3d

3e

3c	Open both lock-offs. Pull off sufficient
	lap and diagonal belt (approx. 600-
	900mm). Feed the belt through the
	lock-off belt guide on the opposite side
	to the buckle and in to the belt tunnel
	(dia 3b). There are two access slots in
	the seat cover to aid feeding of the belt
	through the belt tunnel and underneath
	the seat cover (dia 3b inset).
	Feed the seat belt through the belt
	tunnel and lock-off on the opposite side
	and attach the tongue into the buckle
	(dia 3c).

Pull all the seat belt slack through the child seat ensuring the seat belt is not twisted. When the belt is as tight as possible, close the lock-off on the seat belt buckle side, ensuring that both the lap and diagonal sections of the belt are secured by it (dia 3d inset).

Close the lock-off on the opposite side, ensuring that only the lap section of the belt is secured by it (dia 3d).

Ensure that both lock-offs have been clicked into place.

If the buckle now lies in the position marked as wrong with a and the seat belt cannot be correctly tightened (dia 3e), try another seating position in the car.