Britax BB0-702-00 manual 2b inset

2. Installing your child seat (rearward facing) in rear side seat

2a

2b

2d

IMPORTANT - The child seat MUST only be used with a lap or a lap and diagonal seat belt (approved to UN/ECE regulation no. 16 or equivalent standards).

With the footprop adjusted to the shortest length, place the child seat rearward facing on the car seat with the swinging base resting against the back of the vehicle seat. After installation the gap between the seat in front and the child seat should ideally be a minimum of 10mm (dia 2a).

The child seat can touch the seat in front but must not rest against it. If it does then adjust the car seat in the front without making the driver or passenger sit in an uncomfortable position. If not try another seating position in the car.

2c	Open both lock-offs. Pull off sufficient lap
	and diagonal belt (approx. 600-900mm).
	Feed the belt through the lock-off belt
	guide on the opposite side to the buckle
	and in to the belt tunnel (dia 2b). There
	are two access slots in the seat cover to
	aid feeding of the belt through the belt
	tunnel and underneath the seat cover (dia
	2b inset).
	Feed the seat belt through the belt tunnel
	and lock-off on the opposite side and
	attach the tongue into the buckle (dia 2c).

Pull all the seat belt slack through the child seat ensuring the seat belt is not twisted. When the belt is as tight as possible, close the lock-off on the seat belt buckle side, ensuring that both the lap and diagonal sections of the belt are secured by it (dia 2d inset).

Close the lock-off on the opposite side, ensuring that only the lap section of the belt is secured by it (dia 2d).

Ensure that both lock-offs have been clicked into place.

2e

If the buckle now lies in the position marked as wrong with a and the seat belt cannot be correctly tightened (dia 2e), try another seating position in the car.