Broan EW5630SS manual Install the Hood Non-Ducted Hoods Only, NON-DUCT KIT Model RKE56 Contents

MODELS EW5630SS • EW5636SS

6” ROUND

STEEL DUCT

DUCT LENGTH

DECORATIVE

FLUE

10.Measure and install steel ductwork to hood duct connector and ductwork rough-in on ceiling or wall. Use duct tape to make all joints secure and air tight.

11.Plug power cord into wall outlet.

12.Slide the upper decorative flue section into the lower decorative flue section. NOTE For ducted applications, the louvers on the upper flue should be hidden by positioning the louvers down, inside of the lower flue.

13.Carefully place the upper/lower flue assembly into the recessed area of the hood.

14.Slide the upper flue upward until it is aligned with its mounting bracket. The bracket should be inside the flue. Secure the upper flue to the upper flue mounting bracket using (2) 4mm x 12mm mounting screws.

NOTE

9-10 ft. ceilings may require Flue Extension Model FXNE56SS depending on installation height (purchase separately). Discard the upper and lower flues supplied with your hood and replace them with Flue Extension Model FXNE56SS.

Page 5

INSTALL THE HOOD (Non-Ducted Hoods Only)

NON-DUCT KIT MODEL RKE56 CONTENTS

	2 MOUNTING
	SCREWS
	(4mm x 38mm
	Cross Recessed
NON-DUCT PLENUM	Pan Head)
ASSEMBLY	4 MOUNTING
	SCREWS
	(.188” x .375”
	Cross Recessed
	Flat Head)
	FILTER TRAY
FLEXIBLE DUCT
	NON-DUCTED RECIRCULATION FILTERS

NOTE

Non-ducted installations require Non-Duct Kit, Model RKE56 (purchase separately).

Ceiling

Flush with

the ceiling

Upper flue mounting

bracket slots

C

L

Center of

installation

1.Center the non-duct plenum over the hood location and flush with the ceiling. Secure the non-duct plenum to the wall using

(2) 4mm x 38mm mounting screws.

2.Tighten the screws completely. Make sure that the non-duct plenum is tight against the wall.

3.Remove damper flaps from damper / duct connector and discard flaps.