Broan EW5636SS, EW5630SS manual Install the Hood Ducted Hoods Only

MODELS EW5630SS • EW5636SS

INSTALL THE HOOD (Ducted Hoods Only)

Ceiling	Center of
	installation
	C
	L	Flush with
	Upper flue mounting
		the ceiling
	bracket slots

1.Center the flue mounting bracket over the hood location and flush with the ceiling. Secure the upper flue bracket to the wall using (2) 4mm x 38mm mounting screws. Note: Drywall anchors may be needed (not included).

2.Tighten the screws completely. Make sure that the bracket is tight against the wall and ceiling.

3.Remove (3) screws holding electronics mounting bracket to hood. Rotate bracket 180 degrees and re-attach bracket to hood with same (3) screws.

Page 4

6.Align the keyhole slots on the hood with the mounting screws that were partially tightened into the wall framing. Ensure that hood is seated entirely on mounting screws, and that hood is level. Then tighten screws completely.

7.Install (2) 4mm x 38mm long screws into the holes inside the hood and tighten them securely.

4.Remove the protective plastic film covering the decorative flue and the hood at this time.

5.Remove the grease filter by pulling down the metal latch tab and tilting filter downward to remove.

8.Carefully place glass canopy on top of the hood. Align nuts on glass canopy with holes inside the hood. Attach canopy with (4) .188” x .250” long flat head screws. Tighten screws securely but DO NOT OVERTIGHTEN.

9.Reinstall grease filter by aligning side filter tab with slots in the hood. Pull down the metal latch tab, push filter into position and release. Make sure filter is securely engaged after installation.