Icom iC-706MKTMG, HF/VHF/UHF ALL MODE TRANSCEIVER manual Installation, DOperation

10 OPTIONAL INSTALLATIONS/SETTINGS

■UT-106DSP RECEIVER UNIT

DInstallation

➀Open the transceiver case as shown on p. 59.

➁Remove the 4-pin connector (P251) from J1413 on the MAIN unit (top side) and plug it into J1 of the UT-106 on the PLL unit (bottom side).

➂Plug the 4-pin connector (P1) from the UT-106 into J1413 on the MAIN unit.

➃Plug the supplied ribbon cable into J3 on the UT- 106 and J253 on the PLL unit.

•Be careful of the orientation of the ribbon cable.

MAIN unit

P1

J1431

Remove the J1431 connector from the PLL unit and replace with the UT-106 connector

➄Attach the UT-106 to the PLL unit, using the exist- ing guide for alignment, as illustrated at right.

➅Reassemble the transceiver.

DOperation

Refer to the instructions supplied with the UT-106 for operating details.

Be careful of the orientation

UT-106when connecting the ribbon cable.

J3

J1

PLL unit

P251

P253

P1

unit position

■MB-72CARRYING HANDLE

The optional MB-72 CARRYING HANDLE is convenient when carrying the transceiver for DX’peditions, field operation, etc.

➀Remove the 2 screws from the right side of the transceiver as shown below.

➁Replace those with 2 supplied screws plus rubber

rubber feet

feet and additionally attach 2 more supplied screws (including rubber feet) as shown below.

•When replacing the 2 screws at the rear, be sure to squeeze the top and bottom covers together to ensure proper alignment.

➂Attach the MB-72 to the left side of the transceiver as shown below.

carrying handle

61