MODELS EW5630SS • EW5636SS
Page 2
MEASURE THE INSTALLATION
| ROOF CAP |
| ROUND ELBOW |
6” ROUND DUCT | WALL CAP |
| |
DECORATIVE FLUE | HOOD MOUNTING |
| |
3¾” FROM WALL | BRACKET |
| |
TO CENTER LINE |
|
OF DUCT |
|
DECORATIVE FLUE | 15 7/8” TO CENTER |
| OF UPPER BRACKET |
HOOD | HOLES |
3½” |
|
| 2” TO CENTER |
24” TO 36” ABOVE | OF LOWER HOOD |
CHASIS HOLES | |
COOKING SURFACE |
|
The minimum hood distance above cooktop MUST NOT BE LESS than 24”.
A maximum of 36” above cooktop is recommended for best capture of cooking impurities.
Distances over 36” are at the installer and users discretion; providing that the ceiling height permits.
INSTALL THE DUCTWORK (Ducted Hoods Only)
1.Decide where the ductwork will run between the hood and the outside.
2.A straight, short duct run will allow the hood to perform most efficiently.
3.Long duct runs, elbows and transitions will reduce the performance of the hood. Use as few of them as possible. Larger ducting may be required for best performance with longer duct runs.
4.Install wall cap or roof cap. Connect round metal ductwork to cap and work back towards the hood location. Use duct tape to seal the joints between ductwork sections.
PREPARE THE HOOD
Unpack hood and check contents.You should receive:
1 - Hood Assembly
1 - Glass Canopy
1 - Decorative Flue Assembly (consisting of upper and lower flue)
1 - Upper Flue Mounting Bracket
1 - Aluminum Grease Filter (installed on hood)
2 - 35W MR16 GU10 Halogen Lamps (installed on hood)
1 - Parts Bag containing:
6 - Mounting Screws (4mm x 38mm Cross Recessed Pan Head) 2 - Mounting Screws (4mm x 12mm Cross Recessed Pan Head) 4 - Mounting Screws (.188” x .250” Cross Recessed Flat Head) 1 - Suction Cup Tool
1 - Installation Manual
| 2 MOUNTING | |
| SCREWS | |
UPPER | (4mm x 12mm | |
Cross Recessed | ||
FLUE MOUNTING | ||
Pan Head) | ||
BRACKET | ||
| ||
| DECORATIVE | |
| FLUE | |
| ASSEMBLY | |
4 MOUNTING |
| |
SCREWS |
| |
(.188” x .250” |
| |
Cross Recessed |
| |
Flat Head) |
| |
| 6 MOUNTING | |
| SCREWS | |
| (4mm x 38mm | |
| Cross Recessed | |
| Pan Head) | |
| GLASS | |
| CANOPY | |
BULB | HOOD | |
ASSEMBLY | ||
SUCTION | ||
| ||
CUP TOOL |
|
