MODELS QP130BL • QP130BLC • QP130SS • QP130SSC QP130WW • QP130WWC • QP136BL • QP136SS • QP136WW

HOUSE

POWER CABLE

12 Run House Power Cable between service panel and hood location. Attach power cable to hood using appropriate clamp.

13 Hang hood from (5) mounting screws driven part-way into cabinet locations (shown in illustrations under “PREPARE HOOD LOCATION”). Mounting screws are included in parts bag. Slide hood back towards wall until mounting screw heads are engaged in narrow end of keyhole slots in top of hood. Tighten screws securely.

14DUCTED INSTALLATION ONLY:

Connect ductwork to hood and use duct tape to make joints secure and air-tight. Make sure the damper / duct connector enters the ductwork and that the damper opens and closes freely.

CONNECT THE WIRING

HOUSE

POWER

CABLE

GROUND

SCREW

15 Connect House Power Cable to range hood wiring - BLACK to BLACK, WHITE to WHITE, and GREEN or

BARE WIRE to Ground Screw. Replace electrical wiring box cover.

Page 5

INSTALL LIGHT BULBS

 

SUCTION

 

CUP TOOL

HALOGEN

(1)

PUSH IN

BULB

 

(2)

 

ROTATE

 

CLOCKWISE

 

LIGHT PANEL

LIGHT PANEL

SCREWS

 

CAUTION: Bulbs may be hot. Refer to bulb packaging for further information.

16 Install (4) Halogen Bulbs. Use 120 V, 35 W, shielded halogen bulbs - MR16 with GU10 base. Purchase bulbs

separately.

NOTE: Suction Cup Tool (included with hood) can be used to install and remove light bulbs.

Align pins on bulb with large diameter opening on socket, then push bulb in towards hood and rotate clockwise until firmly seated.

The position of the bulb socket (depth) is adjustable and may be necessary when:

a)certain brands of bulbs are difficult to install.

b)the bulb protrudes too far below the light panel.

LAMP SOCKET

BRACKET

LIGHT

SCREWS

PANEL

To change the depth of bulb sockets:

-Remove 2 Light Panel Screws. Set screws aside.

-Loosen 2 Screws holding Lamp Socket Bracket to Light Panel.

-Adjust socket/bracket to desired depth.

-Re-tighten screws securely.

-Re-attach light panel.

17DUCTED INSTALLATION ONLY:

Re-install aluminum filters removed in Step 5.

NON-DUCTED INSTALLATION ONLY:

Install aluminum filters and non-ducted filters - purchased and assembled in Step 8.

Page 5
Image 5
Broan QP136SS, QP130WW Connect the Wiring, Install Light Bulbs, Loosen 2 Screws holding Lamp Socket Bracket to Light Panel