INSTALL FLUE MOUNTING BRACKET
DUCTED AND NON-DUCTED HOODS
1.Assemble the flue mounting bracket, adjusting outside width as shown. Fig.8
2.Carefully center the mounting bracket directly over the range hood location.
3.Secure the bracket assembly to the ceiling using (2) 4.8x38mm mounting screws and drywall anchors (Fig. 9). Make sure the bracket is pushed into the corner, tight against the wall and centered over the hood.
FLUE MOUNTING BRACKET
3.9x 6 mm FLAT HEAD BRACKET SCREWS
(24.9 cm)
FIG. 8
DRYWALL ANCHORS |
|
4.8x38mm |
|
MOUNTING SCREWS | FIG. 9 |
PREPARE THE HOOD
Note: On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the hood and decorative flues, prior to final installation.
DUCTED HOODS ONLY
1.Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Fig.10.
2.Install the discharge collar into the duct connector of the range hood. Fig. 11.
ELECTRICAL
SYSTEM PLATE
DISCHARGE
COLLAR
DUCT
CONNECTOR
PROTECTION
FIG.10
- 10 -