Broilmaster Q3XN-1 Heat Shield / Wind Shield, Burner Bracket Securing Bolt, Ignitor Wire

GRILL ASSEMBLY

Heat Shield / Wind Shield

Place the heat and wind shield in the grill bottom.

See Figure 9.

Figure 9

Burner Bracket Securing Bolt

1.Insert the 1/4-20 x 1 1/2 Phillips Truss Head Screw from the underside of the grill and secure with the 1/4-20 Hex Nut. See Figure 10.

Figure 10

Note: If the Grill Head is installed on a PCB1, PSCB or DCB1, make sure the cart shield is not installed until the burner bracket securing bolt is installed.

2.Install Grill Head on a Cart or Post Mounting (see Cart or Post Installation Instructions that come with the mounting option).

Ignitor Wire

Note: Install the Ignitor Ground Wire before installing the burner.

1.Connect the ground wire to the ground lug on the collector box before installing the burner into the grill. See Figure 11.

Figure 11

B101748-1-0512 Page 15