Broilmaster Q3XN-1 owner manual Install the Burner, Connect Igniter Wires and Install Battery

GRILL ASSEMBLY

Install the Burner

1.Insert the burner assembly into the grill bottom with the venturi tubes facing the front of the grill. See Figure 12.

2.Carefully slide the wires through the same hole in the bottom of the grill.

5.Slide the bridge pin through the hole in the 1/4-20 x 1 1/2 Phillips Truss Head Screw as shown in Figure 14.

Figure 12

3.Slide the venturi on to the valve assembly.

4.Raise the unsecured end of the burner bracket and slip it over the 1/4-20 x 1 1/2 Phillips Truss Head Screw as shown in Figure 13. The screw will fit into the hole on the burner bracket.

Figure 13

Figure 14

Connect Igniter Wires and Install Battery

1.Attach ground and igniter wires to the igniter as shown in Figure 15.

2.Remove push button cap and insert AA battery, positive side down, as shown in Figure 15.

Figure 15

Page 16 B101748-1-0512