GRILL ASSEMBLY
Assemble Drain Pan
Note: Drain pipe and valve coponents are packed inside the smoker box.
1.Lightly spread pipe sealant on all threads before assem- bling to the drain pan.
2.Thread the 3/4” pipe into the bottom of the drain pan and tighten.
3.Assemble the two 45° elbows as shown in Figure 23. Note: Make sure of the mountings (posts, carts, etc.) being used before tightening to ensure that the fittings are set to the proper position.
FOR USE ON ALL POSTS
AND DCB AND PCB CARTS
| DRAIN PAN |
| 3/4” PIPE |
PIPE SEALANT OR |
|
TEFLON TAPE | 45° ELBOWS |
|
Install the Drain Pan Assembly
1.Lower the drain pan into the lower casting with the drain pipe on the right side. Pass the pipe through the oval hole in the bottom of the casting, making sure the pipe extends out through the bottom of the casting and the pan is sitting level on the holding tabs. See Figure 24.
2.Slide the drain bucket hanger into place over the pipe and screw on the drain shut off valve and tighten. Note: Position Drain Shut Off Valve so it does not interfere with the wall of the grill head.
DRAIN BUCKET HANGER
DRAIN SHUT OFF VALVE
FOR USE ON PSCB CART
| DRAIN PAN |
| 3/4” PIPE |
PIPE SEALANT OR |
|
TEFLON TAPE | 45° ELBOWS |
|
Figure 23
Figure 24
3.Set cooking grids in place.
Note: The grids are designed for two levels of cooking.
4.Hang the drip bucket on the drain bucket hanger.
NOTE: If the grill was installed on a cart, make sure to install the cart’s heat shield before use.
Page 19 |
