Brother 885-S61 operation manual Lcd

APPENDIX —————————————————————————————————————————————————————

Symptom	Probable Cause	Remedy	Reference
▲	The pressure of the presser foot is	Turn the presser foot pressure dial to
		the right to increase the pressure of	page 39
	weak.
		the presser foot.
	The thread is tangled, for example,	Remove the tangle thread. If the
		thread is tangled in the shuttle, clean	page 135
The fabric does	in the shuttle.
		the shuttle.
not feed.
		Use the presser foot locking pin
	Zigzag foot “J” is slanted on a thick	(black button on the left side) on	page 63
	seam at the beginning of stitching.	zigzag foot “J” to keep the presser
		foot level while sewing.
The sewing lamp	The sewing lamp is damaged.	Contact your retailer or the nearest	–
does not come on.		authorized service center.
Nothing appears	The brightness of the LCD is either	Adjust the brightness of the LCD.	page 142
in the LCD.	too light or too dark.
While winding
the bobbin, the
bobbin thread	You have not wound the bobbin	After removing the thread wound
was wound		below the bobbin winder seat, wind	page 18
	thread properly.
below the		the bobbin correctly.
bobbin winder
seat.
	The thread is not passed through the	Correctly pass the thread through the
	bobbin-winding thread guide		page 20
		bobbin-winding thread guide.
	correctly.
Bobbin thread
		Move the sewing speed controller to
does not wind
	Bobbin spins slowly.	the right (so that the speed will be	page 21
neatly on the
		fast).
bobbin.
	The thread that was pulled out was	Wind the thread that was pulled off
	not wound onto the bobbin	round the bobbin five or six times	page 20
	correctly.	clockwise.
Fabric being
sewn with the	Thread is tangled below the needle	Lift up the fabric and cut the threads	page 135
machine cannot	plate.	below it, and clean the race.
be removed.
The fabric feeds		Contact your dealer or the nearest
in the opposite	The feed mechanism is damaged.		–
		authorized service center.
direction.
The upper	The bobbin thread is incorrectly
thread has		Correctly install the bobbin thread.	page 22
	installed.
tightened up.
The thread is
tangled on the	You have not threaded the upper	Correct the upper threading.	page 24
wrong side of	thread properly.
the fabric.

140