Brother 885-S61 operation manual DPress start/stop button once, EPress start/stop button once

CAUTION

●Be sure to cut the thread as described on the previous page. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin or the needle may bend or break when the bobbin thread starts to run out.

cSlide the sewing speed controller to the right (so that the speed will be fast).

1

1Sewing speed controller

dPress (start/stop button) once.

When the foot controller is plugged in, press down on the foot controller.

1

1Start/stop button

XThe bobbin starts spinning and the thread is wound around the bobbin.

XThe bobbin stops spinning when it is full.

ePress (start/stop button) once.

When the foot controller is plugged in, remove your foot from the foot controller.

XThe sewing machine stops.

fUse scissors to cut the end of the thread wound around the bobbin.

1

gSlide the bobbin winder shaft to the left.

Memo

●If the bobbin winder shaft is set to the right side, the needle will not move. (Sewing is impossible.)

hRemove the bobbin from the shaft.

iSlide the sewing speed controller back to its original position.

CAUTION

●Use a bobbin thread that has been correctly wound, otherwise the needle may break or the thread tension will be incorrect.

Memo

●When the sewing machine is started or the balance wheel is turned after winding the thread around the bobbin, the machine will make a clicking sound; this is not a malfunction.

Winding/Installing the Bobbin 21