Brother 885-V31/V33 operation manual Pass the thread through the eye of the needle from the front

————————————————————————————————————————————————————

dInsert the extra spool pin into the end of the bobbin winder shaft, and install the thread spool on it. Then, thread the upper thread.

aBobbin winder shaft

bExtra spool pin

cThread spool

Memo

zWhen setting the thread spool, set it so that the thread winds off from the front of the spool.

eThread the upper thread for the right side in the same way that the upper thread for the left side was threaded.

•For details, refer to steps g through j of "Threading the upper thread" (page 33).

fWithout passing the thread through the needle bar thread guide, manually thread the right needle.

Pass the thread through the eye of the needle from the front.

1

CAUTION

●The needle threader cannot be used with the twin needle. If the needle threader is used with the twin needle, the sewing machine may be damaged.

gAttach zigzag foot "J".

For details on changing the presser foot, refer to "Replacing the Presser Foot" (page 43).

CAUTION

●When using the twin needle, be sure to attach zigzag foot "J". If bunched stitches occur, use presser foot "N" or attach stabilizer material.

hTurnstitch.on the sewing machine and select a

•For stitch selection see "Selecting stitching" (page 49).

•See "Stitch Setting Chart" (page 70) for stitches that use a twin needle.

CAUTION

●When using the twin needle, be sure to select an appropriate stitch, otherwise the needle may break or the machine may be damaged.

Upper Threading 37