Brother 885-V31/V33 operation manual When the thread became tangled under the bobbin winder seat

GETTING READY ————————————————————————————————————————————

oCut the thread with scissors, slide the bobbin winder shaft to the left, and then remove the bobbin from the shaft.

Memo

zIf the bobbin winder shaft is set to the right side, the needle will not move. (Sewing is impossible.)

pSlide the sewing speed controller back to its original position.

Memo

zWhen the sewing machine is started or the handwheel is turned after winding the bobbin, the machine will make a clicking sound; this is not a malfunction.

■When the thread became tangled under the bobbin winder seat.

If the bobbin winding starts when the thread is not passed under the pretension disk of the bobbin- winding thread guide correctly, the thread may become tangled under the bobbin winder seat.

In such a case, wind off the thread according to the following procedure.

b

a

aThread

bBobbin winder seat

CAUTION

●Do not remove the bobbin winder seat even if the thread become tangled under the bobbin winder seat. It may result in injuries.

●Do not remove the screw of the bobbin winder presser, otherwise the machine may be damaged; you cannot wind off the thread by removing the screw.

a

aScrew of the bobbin winder presser

aIf the thread become tangled under the bobbin winder seat, press (Start/stop button) once to stop the bobbin winding.

When the foot controller is plugged in, remove your foot from the foot controller.

a

aStart/stop button

26