Brother 885-V32 appendix Eyelet Stitching, or Eyelet stitch, Belts 15/64

UTILITY STITCHES ———————————————————————————————————————————

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4, 15/ 64 and 3/16 inch).

			Stitch Width		Stitch Length		Presser
Stitch Name	Pattern	Application	[mm (inch)]		[mm (inch)]
							Foot
			Auto	Manual	Auto	Manual
	62			7.0, 6.0 or		7.0, 6.0 or
Eyelet stitch		Sewing eyelets, for example, on	7.0	5.0	7.0	5.0	N
		belts	(1/4)	(1/4, 15/64	(1/4)	(1/4, 15/64
				or 3/16)		or 3/16)

CAUTION

●Be sure to turn off the main power before replacing the pressor foot. Otherwise, injuries may occur if (Start/stop button) is accidentally pressed and the machine starts sewing.

aAttach monogramming foot "N".

•For details on replacing the presser foot, refer to "Replacing the presser foot" (page 43).

bSelect stitch 62 .

•For details, refer to "Selecting stitching" (page 49).

cAdjust either the stitch width or the stitch

•For details,￿￿￿refer￿￿￿to "Adjusting￿￿￿the stitch width" (page 57) and "Adjusting the stitch length" (page 59).length to select the desired eyelet size.

dLower the needle into the fabric at the beginning of the stitching, and then lower the presser foot lever.

eStart sewing.

X Once sewing is completed, the sewing machine automatically sews reinforcement stitches, then stops.

fUse the eyelet punch to cut a hole in the center of the eyelet.

When using the eyelet punch, place thick paper or some other protective sheet under the fabric before punching the hole in the fabric.

Memo

zIf thin thread is used, the stitching may be too open. If this occurs, sew the eyelet twice before removing the fabric, one on top of the other.

108