Brother 885-V32 appendix Thread runs out partway through a design, Stopping while embroidering

EMBROIDERY —————————————————————————————————————————————

Thread runs out partway through a design

When the upper thread or the bobbin thread runs out while sewing, the sewing machine stops. Move the needle back about 10 stitches and resume sewing.

Memo

zWhen the bobbin thread runs out, cut the threads and remove the embroidery frame before replacing the bobbin thread.

aSet up the upper or bobbin thread.

b Press .

Memo

zIf the needle count is not displayed, display the needle count on the screen. For details, refer to "Stopping while embroidering" (page 148).

cPress .

dPress (Back one stitch) to move the needle back about 10 stitches.

(Forward one stitch) increases the stitch number.

Stopping while embroidering

If the embroidery is stopped before it is complete, check the current needle count and layout before turning off the sewing machine.

Memo

zWhen the sewing machine is turned off, the embroidery size and layout return to the original setting. If you have changed the layout, you need to adjust it again.

aPress (Start/stop button) to stop the sewing machine.

bCheck the current needle count on the screen and make a note of it.

If the needle count is not displayed, press

(Settings key), and then use to display the following screen.

Press to return to the previous screen.

cPress (Embroidery key).

eRestart the embroidery.

X The confirmation message is displayed.

148