Brother 885-V32 appendix Saving stitch settings, Default stitch length is 2.5 mm, EPress

SEWING BASICS ————————————————————————————————————————————

Saving stitch settings

This machine is preset with the default settings for the stitch width (zigzag width), stitch length, programmed thread-cutting, and automatic reverse/ reinforcement stitching for each stitch. However, if you wish to save specific settings for a stitch so that

they can be used later, press after changing the settings to save the new settings with the selected stitch. This feature can be used only with utility stitches. The settings you saved will not be cleared if the machine is turned off.

■To use a stitch length of 2.0 mm for the straight stitch

aSelect a straight stitch.

bPress .

Memo

zThe default stitch length is 2.5 mm.

cSet the stitch length to 2.0 mm.

dPress .

•To reset the selected stitch patterns to its

default settings, press , and then

press .

Note

zAll stitch settings (stitch width (zigzag width), stitch length, programmed thread- cutting, and automatic reverse/ reinforcement stitching, etc.) are saved, not just the setting that was changed. When the same stitch pattern is selected, the last settings saved are displayed even if the machine was turned off. If the settings are

changed again and is pressed, or if

is pressed to reset the setting to its default, the new settings are not saved unless

is pressed another time.

Even if is pressed, the settings for programmed thread-cutting and automatic reverse/reinforcement stitching are saved in the machine.

XThe confirmation message is displayed.

ePress .

XThe next time that the same straight stitch is selected, the stitch length is set to 2.0 mm.

64