Brother 885V97, 885V95 Installing the bobbin, EWind the bobbin again, Actual size, This model

————————————————————————————————————————————————————

bCut the thread with scissors beside the bobbin- winding thread guide.

a

aBobbin-winding thread guide

cSlide the bobbin winder shaft to the left, and then remove the bobbin from the shaft.

dHold the thread end with your left hand, and wind off the thread clockwise near the bobbin with your right hand as shown below.

eWind the bobbin again.

Note

￿Make sure that the thread passes under the pretension disk of the bobbin-winding thread guide correctly (page 24).

Installing the bobbin

Install the bobbin wound with thread.
CAUTION	1

●Use a bobbin that has been correctly wound with thread, otherwise the needle may break or the thread tension will be incorrect.

●The included bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB).

Actual size

11.5mm

(7/16 inch)

This model Other model

Memo

￿The order that the bobbin thread should be passed through the bobbin case is indicated by marks that surround the bobbin case.

Winding/Installing the Bobbin 27