CAUTION
●Before replacing the needle, place fabric or paper under the presser foot to prevent the needle from falling into the hole in the needle plate.
4Hold the needle with your left hand, and then use an oval screwdriver to turn the needle clamp screw counterclockwise to remove the needle.
2 1
1Use an oval screwdriver
2 Needle clamp screw
•Do not use excessive force when loosening or tightening the needle clamp screw, otherwise certain parts of the sewing machine may be damaged.
5With the flat side of the needle toward the back of the machine, insert the needle until it touches the needle stopper. Next, tighten the needle clamp using an oval screwdriver.
2
3
1 | 1 | Use an oval |
| screwdriver | |
|
| |
| 2 | Needle stopper |
| 3 | Needle |
Install the twin needle in the same way.
CAUTION
● Make sure you insert the needle until it | 1 |
touches the stopper, and securely tighten |
|
the needle clamp screw with an oval |
|
screwdriver, otherwise the needle may |
|
break or the machine may be damaged. |
|
Changing the presser foot
CAUTION
●Always turn off the machine before you change the presser foot. If you leave the power on and step on the controller, the machine will start and you may be injured.
●Always use the correct presser foot for the stitch pattern you have chosen. If you use the wrong presser foot, the needle may strike the presser foot and bend or break, and may cause injury.
●Only use presser feet that have been designed to be used with this machine. Using any other presser foot may cause accident or injury.
You will have to change the presser foot depending on what you want to sew and how.
1Turn off the machine. Raise the presser foot lever.
2Raise the needle by turning the handwheel toward you (counterclockwise) so that the mark on the wheel points up.
3Press the black button at the back of the presser foot holder to release the presser foot.
1
2
3 | 1 | Black button |
| 2 | Presser foot holder |
| 3 | Presser foot |
4Put a different presser foot on the needle plate so that the bar on the presser foot is in line with the slot on the shank.
8