Brother BES-941BC instruction manual Setting of Mending, Press Select by pressing

Chapter 5 Setting

Setting of Mending

Details of mending can be set in case of a thread breakage.

Contents of each setting item are as described below.

ItemContents

For setting a mending end point (number of stitches before a thread

breakage) within the range of 1 ~ 10.

This function is previously set to 1 stitches upon shipments.

For setting whether to reset a thread breakage error automatically

This function is previously set to (Manual) upon shipments.

For resetting an error automatically

For resetting an error manually

For setting whether to stop embroidering temporarily at the mending end point

For stopping embroidering at the mending end point

For stopping embroidering temporarily at the mending end point and then starting all heads automatically

For not stopping embroidering at the mending end point and continuing embroidering

Manually trim the lower thread immediately after resetting a thread breakage error if feeding by stitch back is long (i.e., 40 to 50 mm or more) in this mode.

Set the thread trimming method to .

For setting a thread trimming method using the immediately after resetting a thread breakage error. (This setting is effective only once

after resetting the error.)

For trimming both upper and lower threads

For trimming the lower thread only

For not trimming any thread

Refer to "Mending" ( Page 127).

1.Press .

2.Select by pressing .

3.Press .

100 BES-941BC • BES-1241BC