CHAPTER 4 OPTIONS

The following type of SIMMs can be installed:

•1 MByte HITACHI HB56D25632B-6A, -7A

•2 MByte HITACHI HB56D51232B-6A, -7A

•4 MByte HITACHI HB56A132BV-7A, 7AL, -7B, -7BL

•8 MByte HITACHI HB56A232BT-7A, -7AL, -7B, -7BL

•16 MByte TOSHIBA THM324000BSG-70

•32 MByte TOSHIBA THM328020BSG-70

This printer can accept the following types of SIMMs;

Speed

60 nsec - 80 nsec

Pin Type

72 pin

Height

25.4 mm (1") or less

Output

32 bit or 36 bit

✒Note

The printer has only one slot for a SIMM upgrade.If you want to increase your printer memory again after you have installed a SIMM module into the slot, you will need to remove the previously installed SIMM first. For example if you have previously increased your memory from the standard 4 MB to 8 MB by adding a 4 MB SIMM and you wish to increase your total memory to 12 MB, you need to remove the installed 4 MB SIMM and install the new 8 MB SIMM into the printer.

Installing the SIMM

When you install the SIMM, follow these steps:

1.Turn off the power switch and unplug the power cord from the AC outlet. Then, disconnect the interface cable from the printer.

Fig. 4-3 Unplug the power cord and

disconnect the interface cable

✒Note

Be sure to unplug the power cord to the printer before installing or removing the SIMM and the main controller board.

4–7