3 - 6 CONTROL PANEL
Table 1: LED indications while pressi ng Go and Job Cancel
Make a note of the indication and report the error status to your dealer or a Brot her authorized servi ce
representative by referring to the above table.
*1 If this error occurs, turn the power switch off, wait a few seconds, and then turn it on again.
Leave the printer for 10 minutes with the power on. If th e error occurs again, consult your dealer or
Brother authorized service representative.
LEDs Fixing unit
failure*1Laser unit
failure Main motor
failure Main PCB
failure Engine PCB
failure DIMM failure
Toner
Drum
Paper
Status
Make sure that the front cover is fully closed before you report a service call.