For Wireless Network Users

18 One-push configuration using WPS or AOSS™

(Windows® and Macintosh)

a Confirm your wireless access point/router has the WPS or AOSS™ symbol as shown below.

b Place the Brother machine within range of your WPS or AOSS™ access point/router. The range may differ depending on your environment. Refer to the instructions provided with your access point/router.

c On your machine, press Menu. Press Network.

Press WLAN. Press WPS/AOSS.

When Switch Network interface to wireless? is displayed, press Yes to accept. This will start the wireless setup wizard.

To cancel, press No.

Note

If your wireless access point/router supports WPS (PIN Method) and you want to configure your machine using the PIN (Personal Identification Number) Method, see Configuration using the PIN Method of Wi-Fi Protected Setup in the Network User’s Guide.

d When the LCD shows Start WPS or AOSS, press the WPS or AOSS™ button on your wireless access point/router. See the user’s guide for your wireless access point/router for instructions.

Then press OK and your machine will now automatically detect which mode (WPS or AOSS™) your wireless access point/router uses and try to connect to your wireless network.

e A connection result message appears for 60 seconds on the LCD and a wireless LAN report will automatically be printed.

If the connection failed, check the error code on the printed report and refer to Troubleshooting on page 35.

Wireless setup is now complete. A four level indicator at the upper right of your machine’s LCD will show the wireless signal strength of your access point/router.

To install MFL-Pro Suite, continue to step 19.

For Windows® Users:

Now go to

Page 37

For Macintosh Users:

Now go to

Page 40

34