Brother NV1250D Eyelet Stitching

Eyelet Stitching 117
3
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Eyelet Stitching
Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm
(1/4, 15/64 and 3/16 inch).
aAttach monogramming foot “N”.
• For details, refer to “Replacing the presser
foot” (page 44).
bSelect stitch 62 .
• For details, refer to “Selecting stitching” (page
51).
cAdjust either the stitch width or the stitch
length to select the desired eyelet size.
a7mm
b6mm
c5mm
• For details, refer to “Adjusting the stitch
width” (page 58) and “Adjusting the stitch
length” (page 59).
dLower the needle into the fabric at the
beginning of the stitching, and then lower the
presser foot lever.
eStart sewing.
XOnce sewing is completed, the machine
automatically sews reinforcement stitches,
then stops.
fUse the eyelet punch to cut a hole in the
center of the eyelet.
• When using the eyelet punch, place thick
paper or some other protective sheet under
the fabric before punching the hole in the
fabric.
Memo
zIf thin thread is used, the stitching may be
too open. If this occurs, sew the eyelet twice
before removing the fabric, one on top of the
other.
Stitch Name Pattern Application
Stitch Width
[mm (inch)] Stitch Length [mm (inch)] Presser
Foot
Auto Manual Auto Manual
Eyelet stitch 62 Sewing eyelets, for example, on
belts 7.0 (1/4)
7.0, 6.0 or
5.0
(1/4, 15/64
or 3/16)
7.0
(1/4)
7.0, 6.0 or
5.0
(1/4, 15/64
or 3/16)
N
123