Brother PC 8500 manual Embroidering, Start the machine once more, Is being displayed

Embroidering

Always use Brother embroidery thread.

Select from different thread qualities to achieve a variety of results.

Example:

1.Select the desired pattern.

The order of sewing for each part will be displayed.

*The color displayed below each pattern is for reference. Some color regions may not have a color displayed below them; you can sew these parts with any color you like.

2. Thread the needle for the first color and pass it through embroidery foot “Q”. Hold this thread in your left hand while leaving a certain amount of slack in the thread.

* Be sure to raise the presser foot lever before threading the needle.

3. Lower presser foot lever and start embroidering. After 5 to 6 stitches have been sewn, stop the machine and cut off any surplus thread from the end of the seam.

*If you are using the embroidery unit, the foot controller cannot be used at this time.

* Sewing can start even if “ ” is being displayed.

4.Start the machine once more.

The part indicated by (1) in the illustration will be embroidered and the machine will then stop automatically. Once embroidering is completed, the display will automatically move to the left and the next color to be embroidered will be displayed at the left edge of the screen.

(1)

120

Setting Up
Sewing
Stitches	Utility
Stitches	Decorative	Characters and
Embroidering
Patterns	Embroidery	Editing
Retrieving
Stitch TM	Custom	My
Maintenance
Messages	Error
shooting	Trouble
Chart	Sewing
in Machine)	(Programmed	Patterns
Card)	(Memory	Patterns