Brother PC 8500 manual Extra spool pin, Spool felt, Net Thread spool, Spool pin Spool cap

* Rotating your right hand slightly to check that the thread is engaged.

4.While gently holding the thread, raise the needle threader lever.

3

5

5.	Pull the thread towards the rear to finish the upper
	threading.
5
6.	Pass the thread underneath the presser foot and pull it out
	from the rear of the machine by about 5 cm (1-15/16”).

	Using the extra spool pin and the net
Extra spool pin
Use when embroidering with metallic thread.		3
1.	Insert the extra spool pin into the end of the bobbin winder shaft.
2.	Install the spool felt and the thread spool in that order, and then thread the upper	2

thread.

1Insert the extra spool pin into the end of the bobbin winder shaft

2 Spool felt 1

3Thread spool

*When setting the thread spool, set it so that the thread winds off from the front of the spool.

*If using metallic thread, we recommend that you use a 90/14 home sewing

machine needle.

Note

This method keeps the thread from twisting as it comes off the spool pin.

Net

If using special threads which wind quickly off the thread spool, attach a net to the spool before using.

*Cut the net to match the size of the spool.

1	Net	1
2	Thread spool	4

3Spool pin

4 Spool cap

2 3 4

Setting Up
Sewing
Stitches	Utility
Stitches	Decorative	Characters and
Embroidering
Patterns	Embroidery	Editing
Retrieving
Stitch TM	Custom	My
Maintenance
Messages	Error
shooting	Trouble
Chart	Sewing

Needle	Thread (cotton)
65/9	#30, 50, 60
75/11	#30
90/14	#30
100/16	#20

Note

The auto-threading device cannot be used with the combinations shown at left.

Transparent nylon thread can be used regardless of the chart providing needle used in 90/14 to 100/16.

in Machine)	(Programmed	Patterns
Card)	(Memory	Patterns

21