AC ADAPTER

The AC adapter (model AD-30) allows you to use this machine wherever there is an electrical outlet.

To connect the AC adapter:

1Insert the plug on the adapter cord into the connector marked DC IN 7.0V on the right

side of the machine.

2 Insert the plug on the adapter into the nearest standard electrical outlet.

☞Only use the AC adapter designed exclusively for this machine.

Remove the batteries and disconnect the AC adapter if you do not intend to use this machine for an extended

period of time. When the power is disconnected, all text shown in the display and stored in the memory will be lost.

It is recommended that you use the AC adapter when printing large fonts on 3/4″ (18-mm)-wide tape since this operation can quickly drain the batteries.

TAPE CASSETTE

Two TZ tape cassettes are supplied with this unit. However, since TZ tape cassettes are available for this machine in a wide variety of colors and sizes, it is possible to make distinctive color-coded and stylized labels.

In addition, this machine has been designed to allow you to change the tape cassettes quickly and easily.

To change the tape cassette:

1Lift open the tape compartment cover. The installed cassette is also released.

2 If a tape cassette is already installed, remove it by pulling it straight up.

3If the ink ribbon in the other tape cassette is loose, use your finger to wind the toothed wheel in the direction of the arrow on the cassette until there is no slack in the ribbon. Also, make sure that the end of the tape feeds under the tape guides.

☞If you are using a new tape cassette provided with a stopper, be sure to remove the stopper.

5