For Windows®

4Select the desired baud rate, and then click the Next button.

￿Normally “115,200 bps” is selected; however, your computer may not be able to support a baud rate of 115,200 bps. If this is the case, refer to the your computer’s instruction manual and select the maximum possible baud rate.

A dialog box appears, asking for confirmation of the selected baud rate settings.

5Check that the baud rate will be changed as desired, and then click the Next button.

￿To change the settings, click the Back button, and return to step 4.

A dialog box appears, showing that the baud rate has been set as specified.

6Click the Finish button.

For a USB connection (Windows® 98/Me/2000 Peofessional/XP only)

With Plug-and-Play, new devices connected to the system are detected, and their drivers are automatically installed. If the PT-9200DX is to be connected through the USB port, its driver will be installed with Plug-and-Play. Be sure to read the installation instructions described below before installing the file supplied on the CD-ROM.

￿Do not connect the P-touch 9200DX to the computer until you are instructed to do so, otherwise the PT-9200DX printer driver may not be installed correctly.

With Windows® 98/98SE/Me/2000 Professional:

1Select “USB cable”, and then click the OK button. The USB message dialog box appears.

2Click the Next button. A dialog box appears, instruct- ing you to connect the PT-9200DX to the computer.

3Connect the PT-9200DX to the computer using the enclosed USB interface cable as described on page 5, and then turn on the PT-9200DX. A dialog box appears, showing that the printer driver has been installed.

10