Connecting the interface and power supply cablesConnect the PT-9200DX to the computer according to the instructions below.
When connecting to the serial port:
Serial
1Make sure that both the PT-9200DX and the computer are turned off.
2Connect one end of the enclosed serial interface cable to the serial connector (IOIOI) of the PT-9200DX and the other end of the cable to the serial port of the computer. For a Macintosh connection, connect the PT-9200DX to either the modem or the printer port (preferably the modem port).
The serial (RS-232C) ports of some computers are shaped so that the serial interface cable cannot be con- nected. If this is the case, use a commercially available adapter.
3Insert the plug on one end of the power supply cord into the power supply jack on the PT-9200DX.
4Insert the plug on the other end of the power supply cord into an AC outlet equipped with a grounding terminal. Some locations may require the use of an adapter provided with a grounding wire. Connect this wire to the ground terminal.
5Turn on the PT-9200DX, and then turn on the computer.