Brother QC 1000 operation manual Overcasting Using the Optional Side Cutter

SEWING THE STITCHES

■Overcasting Using the Optional Side Cutter

By using the side cutter, you can do overcasting while cutting the fabric.

CAUTION

•Make sure to only select one of the stitches listed below. Using another stitch may cause the needle to hit the presser foot and break, possibly causing injury.

Memo

Thread the needle manually when using the side cutter, or only attach the side cutter after threading the needle using the needle threader.

Stitch		Presser		Stitch width		Stitch length		Twin
	Stitch name		Applications	[mm (inch)]		[mm (inch)]
Key		foot						Needle
				Auto	Manual	Auto	Manual
	With side cutter		Straight stitch while cutting	0.0	0.0 - 2.5	2.5	0.2 - 5.0
			fabrics					NO
				(0)	(0 - 3/32)	(3/32)	(1/64 - 3/16)
	With side cutter		Zigzag stitch while cutting fabrics	3.5	3.5 - 5.0	1.4	0.0 - 4.0
								NO
				(1/8)	(1/8 - 3/16)	(1/16)	(0 - 3/16)
	With side cutter		Overcasting stitch while cutting	3.5	3.5 - 5.0	2.0	1.0 - 4.0
			fabrics					NO
				(1/8)	(1/8 - 3/16)	(1/16)	(1/16 - 3/16)
	With side cutter		Overcasting stitch while cutting	5.0	3.5 - 5.0	2.5	1.0 - 4.0
			fabrics					NO
				(3/16)	(1/8 - 3/16)	(3/32)	(1/16 - 3/16)
	With side cutter		Overcasting stitch while cutting	5.0	3.5 - 5.0	2.5	1.0 - 4.0
			fabrics					NO
				(3/16)	(1/8 - 3/16)	(3/32)	(1/16 - 3/16)

3

Utility Stitches

aFollow the steps on page 34 to remove the presser foot.

bPosition the fork on the side cutter’s operating lever onto the needle clamp screw.

b

a

aNeedle clamp screw

bOperating lever

Memo

Make sure that the fork of the operating lever is set onto the needle clamp screw firmly.

cPosition the side cutter so that the side cutter pin is aligned with the notch in the presser foot holder, and then lower the presser foot.

b a

aNotch in presser foot holder

bPin

→The side cutter is attached.

77