Brother QC 1000 operation manual Upper Threading, Attach the bobbin cover

LOWER/UPPER THREADING

bGuide the bobbin thread through the groove, following the arrow in the illustration.

Note

•Do not cut the thread with the cutter.

•Do not attach the bobbin cover.

cWhile lightly holding the upper thread, press the “Needle Position” button twice to lower, then raise the needle.

dGently pull the upper thread to pull up the bobbin thread.

→A loop of the bobbin thread comes out from the hole in the needle plate.

ePull out about 100 mm of the bobbin thread, and then pass it under the presser foot toward the rear of the machine, making it even with the upper thread.

a b

aUpper thread

bBobbin thread

fAttach the bobbin cover.

Upper Threading

This section describes how to thread the machine and the needle. The machine is marked with numbers that indicate the threading order.

CAUTION

•Be sure to thread the machine properly. Improper threading can cause the thread to tangle and break the needle, leading to injury.

•When using accessories not included with this machine, attach the accessory to the machine after threading the machine.

7

4, 5

8

6

12,13

11	3 2,16
10
9
14,15	1

aTurn on the machine.

bPress the “Presser Foot Lifter” button to raise the presser foot.

→The upper thread shutter opens so the machine can be threaded.

a

aUpper thread shutter

Memo

This machine is equipped with an upper thread shutter, allowing you to check that the upper threading is performed correctly.

1

Getting Ready

29