KNOWING YOUR SEWING MACHINE —————————————————————————————————————————

gTrim the excess thread above the bobbin.

CAUTION

●Make sure you follow the instructions carefully. If you do not cut the thread completely, and the bobbin is wound, when the thread runs low it may tangle around the bobbin and cause the needle to break.

hPress the foot controller to start.

iWhen the bobbin seems full and begins spinning slowly, take your foot off the foot controller.

jCut the thread, slide the bobbin winder shaft to the left and remove the bobbin.

Memo

●When the sewing machine is started or the handwheel is turned after winding the thread around the bobbin, the machine will make a clicking sound; this is not a malfunction.

●The needle bar does not move when you slide the bobbin winding shaft to the right.

CAUTION

●Winding the bobbin improperly may cause the thread tension to loosen, breaking the needle and resulting in injury.

Lower threading

Install the bobbin wound with thread.

CAUTION

●Winding the bobbin improperly may cause the thread tension to loosen, breaking the needle and resulting in injury.

12

aWound evenly

bWound poorly

●The bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the enclosed bobbin or bobbins of the same type (part code: SA156, SFB: XA5539-151).

Actual size

11.5mm (7/16 inches)

This model

Other models

 

 

CAUTION

●Make sure you turn the power off while threading the machine. If you accidentally step on the foot controller and the machine starts to sew, you could be injured.

aRaise the needle to its highest position by turning the handwheel toward you (counterclockwise) and raise the presser foot lever.

12

aWound evenly

bWound poorly

11