KNOWING YOUR SEWING MACHINE —————————————————————————————————————————

dHold the needle with your left hand, and then use a oval screwdriver to turn the needle clamp screw counterclockwise to remove the needle.

Note

●The needle can be removed by simply loosening the needle clamp screw about one turn. (If the needle clamp screw is loosened too much, the needle clamp (which holds the needle) may fall off. Therefore, do not loosen the needle clamp screw too much.)

aOval screwdriver

bNeedle clamp screw

•Do not apply strong force when loosening or tightening the needle clamp screw, otherwise certain parts of the sewing machine may be damaged.

eWith the flat side of the needle toward the rear of the machine, insert the needle until it touches the needle stopper.

aNeedle stopper

fWhile holding the needle with your left hand, use the oval screwdriver to tighten the needle clamp screw by turning it clockwise.

Install the twin needle in the same way.

CAUTION

●Be sure to insert the needle until it touches the needle stopper and securely tighten the needle clamp screw with the oval screwdriver, otherwise the needle may break or damage may result.

■Installing the needle clamp

If the needle clamp is removed, follow the procedure below to attach it to the needle bar.

aAs seen from the front of the machine, slide the needle clamp onto the needle bar so that the needle clamp screw is on the right side and the needle bar thread guide is at the bottom.

aNeedle clamp screw

bNeedle bar thread guide

cNeedle bar

bAlign the bottom edge of the needle holder with the end of the needle bar, and then tighten the needle clamp screw.

aNeedle bar

bNeedle holder

cNeedle clamp screw

dAlign

17