Bryant manual Typical Wiring Schematics, 502A024, 230-1-60 Units

TYPICAL WIRING SCHEMATICS (cont)

LEGEND

AHA	— Adjustable Heat Anticipator		TH	—	Thermostat-Heating
C	— Contactor Compressor		TRAN	—	Transformer
CAP	—	Capacitor			Marked Wire
CB	—	Circuit Breaker

CC— Cooling Compensator

CDT	— Compressor Discharge Thermostat	Denotes connection point between
COMP	— Compressor Motor	subbase and thermostat
EQUIP	— Equipment	Terminal (Marked)
FU	— Fuse
GND	— Ground	Terminal (Unmarked)
HPS	— High-Pressure Switch
		Terminal Block
HR	— Heater Relay
IFC	— Indoor-Fan Contactor	Field Splice
IFM	— Indoor-Fan Motor
IFR	— Indoor-Fan Relay	Splice (Marked)
JB	— Junction Box

L— Light

LPS	— Low-Pressure Switch	Factory Splice
NS	— Night Setback Switch	Factory Wiring
OAT	— Outdoor-Air Thermostat
OFC	— Outdoor-Fan Contactor	Accessory or Optional Wiring
OFM	— Outdoor-Fan Motor
PL	— Plug Assembly	Field Control Wiring
QT	— Quadruple Terminal
RC	— Run Capacitor	Field Power Wiring
SW	— Switch	To indicate common potential
TB	— Terminal Block
TC	— Thermostat-Cooling	only, not to represent wiring

NOTES:

1.Neutral for 240/416 v supply (Canada only).

2.If any original wires furnished must be replaced, it should be replaced with 90 C or its equivalent.

3.Numbers indicate the line location of used contacts. A bracket over 2 numbers signifies a single-pole double-throw contact. An underlined number signifies a normally closed contact. Plain (no line) number signifies a normally open contact.

4.Must use thermostat HH07AT170, 172 or 174 with subbase HN63AZ176, 177 or 179.

5.Separate field power supply required for electric heater accessory.

502A024, 230-1-60 Units

11