Setting up
Please note that your handset is already registered to the base station.
Plan the location.
Situate your product close enough to the telephone and mains power sockets so that the cables will reach.
Make sure it is at least 1 metre away from other electrical products to avoid interference.
Do not situate the product in the bathroom or other humid areas.
1Connect the power supply and switch on.
Thread the power supply cable and line cord through the square hole in the plinth before fixing to the base.
Plug the power supply cable into the socket on the underside of your base. The power cable connector and socket are coloured red.
WARNING
Please take care that the power supply and telephone line cord are connected to the correct sockets as incorrect placement could damage your equipment.
Once connected, put the plinth back on the base to prevent it from rocking on the table.
There are two positions for the plinth when joining it to the base both can be used for desk mounting and one of them for wall mounting (see wall mounting on page 27).
Plug the power adaptor into the wall socket and switch on. When the power is switched on, the button on your base will light up.
WARNING
Do not connect the telephone line cord to the phone socket until your handset is fully charged. This will prevent the risk of the phone being answered before the battery is charged. Answering the phone before the battery is fully charged may prevent it from reaching its optimum capacity.
10
