To set your handset for manual base selection (with an automatic search default)
This setting tells your handset to search for a specific base signal for 30 seconds. If the signal cannot be found, the handset reverts to automatic selection of the base with the best signal. This setting is recommended where there is an overlap between two or three base stations.
The handset must be switched ON.
STO INT
•Press the STO button.
•Press the INT button. Display shows the numbers of the base stations at which the handset is registered.
•Press the number of the base (from 1 to 4) through which you wish to make calls.
•Press the same number again. This tells the handset to revert to automatic search if the chosen base is unavailable.
•Press STO to confirm.
If you do not wish to allow the handset to revert to automatic signal selection press the base station number just once. This will mean that the handset can only operate through the base you select.
If you move out of range from one base station and into the range of another during a call, you will lose your connection.
If your handset is taken out of range, switch it off, move back into base station range, and then switch on again. This will speed up
34
