INITIAL SETUP
CAUTION – The dispenser is very heavy! Use care when lifting or moving it. Use at least two people to lift or move the dispenser.
6.0" |
MIN. |
1.Set the dispenser on a sturdy counter top. The dispenser requires a minimum of 6.0" air clearance at the rear of the dispenser. For optimum performance, do not let warm air from surrounding machines blow on the
ULTRA
NOTE – The dispenser should be level or slightly lower in front for proper operation.
2.Remove all shipping material, including the compressor support eyebolt, the cooling drum supports, the “Do Not Lift Here” signs from the cooling drums, and the “Rinse Before Using” signs from each hopper. For models without PAF (Powder
3. Remove the rear plastic plug 4. | Place PAF platform assembly 5. | Tighten support rod from top |
from the trim strip between the | on top of the motor covers and | of platform. Retighten motor |
hopper drip trays and loosen | install support rod into hole in | cover screws. |
the auger motor cover screws. | trim strip. |
|
6. Plug RCA cord into ULTRA base 7. | Install each hopper seal over 8. | Press the seals firmly into |
unit. Proceed with steps 7 thru | the flange at the rear of the | place. |
12. | cooling drums as shown. |
|
4 | 32080.0001 021105 |
|