TROUBLESHOOTING
A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem remains after exhausting the troubleshooting steps, contact the
•Inspection, testing, and repair of electrical equipment should be performed only by qualified service person- nel.
•All electronic components have 120 volt ac and low voltage dc potential on their terminals. Shorting of terminals or the application of external voltages may result in board failure.
•Intermittent operation of electronic circuit boards is unlikely. Board failure will normally be permanent. If an intermittent condition is encountered, the cause will likely be a switch contact or a loose connection at a terminal or crimp.
•Solenoid removal requires interrupting the water supply to the valve. Damage may result if solenoids are energized for more than ten minutes without a supply of water.
•The use of two wrenches is recommended whenever plumbing fittings are tightened or loosened. This will help to avoid twists and kinks in the tubing.
•Make certain that all plumbing connections are sealed and electrical connections tight and isolated.
•Keep away from combustibles.
WARNING – • Exercise extreme caution when servicing electrical equipment.
•Unplug the dispenser when servicing, except when electrical tests are specified.
•Follow recommended service procedures
•Replace all protective shields or safety notices
PROBLEM | PROBABLE CAUSE | REMEDY |
Product will not dispense | 1. No water | Water lines and valves to the dis- |
|
| penser must be open. |
| 2. No power or incorrect voltage to | (A1) Check the outlet for 120 volts |
| the dispenser | on two wire 120 volt dispensers. |
|
| (A2) Check the outlet for 200 volts |
|
| or 240 volts ac for two wire 200 volt |
|
| or 240 volt dispensers. |
|
| (A3) Check the outlet for 230 volts |
|
| on two wire 230 volt dispensers. |
|
| (B) Check circuit breakers or fuses. |
| 3. Signal cable unplugged | Signal cable must be plugged in. |
| 4. Hopper is full | Product must not be touching probes |
|
| to fill. |
| 5. Fuse and fuse holder | Refer to Service - Fuse and Fuse |
|
| Holder for test procedures. See |
|
| page 12 |
7 | 41093 040408 |
|
