PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SPRAY OZ/M: | 25.0 | View or enter the actual flow rate coming out of the sprayhead. | ||
This is used to tell the internal controller how fast the water | ||||
DONE | (+) | |||
is flowing. Use the "CALIBRATE FLOW" screen to obtain the |
most current flow rate.
Range: (3.0 to 75.0 oz) or (100 to 2200ml)
CALIBRATE FLOW ?
NOYES
BREW COUNTERS ?
NOYES
SERVICE TOOLS ?
NOYES
FACTORY DEFAULTS
NOYES
This function provides a 60 second test mode to capture water from the sprayhead. This measurement will then give you the numbers to enter into the "SPRAY OZ/M: xx" screen above.NOTE: Should be performed after deliming and/or changing sprayhead. (Will not display when "BrewLogic" is enabled)
Tracks the total number of brew cycles completed.There is one
Allows the testing of individual components and the ability to check the membrane switches for proper function. (Diagnostic tool for troubleshooting purposes only)
Reset ALL of the previously entered brew settings, ad mes- sage, calibrations, etc.
NOTE: Items not affected; Service #, Password, Language, Units, Asset #, Counters and Serial Number.
|
| INITIAL FACTORY DEFAULT VALUES |
|
| |
Brew Lockout | NO |
| ENABLE ENERGY SAVER - | NO | |
BREW | 64 OZ | (2.0L) | ENABLE FRESH TIMER - | NO | |
BREW METER | 1 |
| ENABLE WARMER OFF - | NO | |
ENABLE ADS | NO |
| REFILL - |
| 155 |
PASSWORD | 0 |
| SPRAY | 25.0 oz/M (739ml/M) | |
Language | English |
| Software Version 1.07 & above | ||
Units | English |
| BrewLogic |
| OFF |
SET TEMP | 200° F | (93° C) |
|
|
|
SET READY | 195° F | (90° C) |
|
|
|
ENTER ASSET # - |
| 0 |
|
|
|
PULSE BREW - |
| DISABLED |
|
| |
DRIP TIME - |
| 0:30 |
|
|
|
ENABLE CLEAN - |
| NO | Page 13 |
|
|
|
|
|
| 41154 041708 | |
|
|
|
|
|